close
close

How To Relight A Pilot Light On A Furnace

How To Relight A Pilot Light On A Furnace

How To Relight A Pilot Light On A Furnace. Use a lit match or a lighter, press the reset button, and position the flame to the opening of the pilot light. Amana 90 air command furnace therescipes.info from www.therecipes.info.

How To Relight A Pilot Light On A FurnaceHow To Relight A Pilot Light On A Furnace
How to ReLight a Pilot Light on a Furnace YouTube from www.youtube.com

Turn the knob to pilot. Find the pilot light assembly. Depress the button or knob for about 30 seconds.

Once You Are Sure That The Pilot Light Is On, Release Your Pressure On The Reset Button.

A thermocouple is an electronic device that monitors the pilot light and shuts off the gas valve to the. Keep the reset switch depressed until the pilot light is burning steadily. Turn the gas valve to the “off” setting.

See also  How To Light Pilot Light On Ventless Gas Fireplace References

Turn The Switch “Off” And Wait At Least 5 Minutes To Give Gas From Within The Furnace Time To Disperse.

Keep the reset switch depressed until the pilot light is burning steadily. Next, give the unit about five minutes to allow the already emitted gas to clear away from the chamber. Turn the knob to pilot.

Follow The Pipe Where The Gas Is Coming Out From.

In this episode of repair and replace, vance shows how to relight the pilot light, in a standing pilot furnace. Remove the access lid from your furnace burner compartment. Place carbon monoxide detectors near sleeping areas.

Steps For Relighting The Furnace Pilot Light.

This maintains gas flow to the pilot until the thermocouple gets hot enough to open the main gas valve. Ignite a barbeque lighter or use a lit match and hold it near the pilot opening tip to relight it. The pilot light should light, but keep holding the small button down for about a minute.

Once You Are Sure The Pilot Light Is On, Release Your Pressure On The Reset Button.

Before lighting the furnace’s pilot, make sure you have all of your materials ready. Wait for 10 minutes for the furnace to fully shout down. Hold down the reset button and light the pilot.